{{ $t('shop.all.spaetbestellservice.hinweis') }}
Valve function | 2/2 closed monostable |
Actuation type | Electrical |
Build.width [mm] | 10 |
Normal nominal flow [l/min] | 100 |
Operating pressure [bar] | 0.5 to 6 |
Construction set up | Poppet valve without reset spring |
Reset mode | Pneumatic spring |
Protection category | IP65 |
Pitch dimension [mm] | 10,5 |
Information about operation |
Power supply must be able to deliver at least 1.7 A without a voltage breakthrough, Do not operate without flow, For block assembly with flow max. ambient temperature 45 °C. |
Sealing principle | Hard |
installation position | arbitrary |
Hand assist actuation | none |
Control type | Direct |
Flow direction | Not reversible |
b-value | 0.38 |
C-value [l/sbar] | 0,40 |
Max. switching frequency [Hz] | 1.000 |
Shifting time on at 4 bar and 24 V in new condition [ms] | 0,8 |
Shifting time off at 4 bar and 24 V in new condition [ms] | 0,4 |
Shifting time on at 0.5 bar and 24 V in new condition [ms] | 0,8 |
Shifting time off at 0.5 bar and 24 V in new condition [ms] | 0,5 |
Shifting time on at 6 bar and 24 V in new condition [ms] | 0,9 |
Shifting time off at 6 bar and 24 V in new condition [ms] | 0,4 |
Tolerance shifting time off | +15 %/-25 % |
Tolerance shifting time on | ±15 % |
Operating voltage range DC [V] | 21.6 to 26.4 |
Power-on time | 100 % |
Operating medium | Compressed air to ISO 8573-1:2010 [7:4:4] |
Information about operating and control medium | Oiled operation not possible |
Limits ambient and media temperature | Depending on the switching frequency |
Corrosion resistant class KBK | 2 - moderate corrosion stress |
Bearing temperature [°C] | -20 to 50 |
Permitted surface temperature magnet [°C] | 120 |
Medium temperature [°C] | -5 to 60 |
ambient temperature [°C] | -5 to 60 |
Max. tightening torque Valve fastening [Nm] | 0,70 |
Product weight [g] | 40 |
Electrical connection |
3-wire, cable |
Fastening type | on connection plate |
Pneumatic connection 1 | Connection plate |
Pneumatic connection 2 | Connection plate |
Material information | RoHs compliant |
Seals material | HNBR |
Housing material |
PA reinforced, PPS reinforced |
Screws material | Steel |
KC-mark | KC-EMV |
CE certificate (see declaration of conformity) | to EU EMC directive |
Reverse polarity protection | for operating voltage |
Additional functions |
Spark suppression, Holding current reduction with energy recovery, Protection switch off |
Eingangswiderstand [kOhm] | 34 |
Coil characteristic value | 24 V DC: Low current phase 2 W, high current phase 7 W |
Trigger signal range DC [V] | 3 to 30 |
Information about incoming current |
0,09 - 0,44 mA bei einem Triggersignal von 3 - 15 V, 0,44 - 15,44 mA bei einem Triggersignal von 15 - 30 V, Anstieg linear |
Permitted voltage oscillations | ± 10 % |
Cable length [MTR] | 0,35 |
Cable sleeve material | PUR |
{{ $t('shop.all.gewicht') }} | 40 g / pcs |
{{ $t('shop.display.artikel.zollwarennummer') }} | 84812090 |
{{ $t('shop.all.hersteller') }} | Festo |
{{ $t('shop.all.spaetbestellservice.hinweis') }}
{{ $t('shop.all.wochenendversand.hinweis') }}
An error has occurred, please reload this page and try again.